This guide helps you print the mPOP diagnostic receipt, connect the device via Bluetooth and narrow down the connection issue.
1. Print the diagnostic receipt
- Make sure that receipt paper is loaded.
- Turn off the mPOP.
- Open the printer unit by pressing the front to release the lock, then pull the printer out.
- Press and hold the printer's Multi-Function button.
- Turn on the mPOP and release the button when printing starts.
- Allow the receipt to finish printing.
You can check details such as the printer's firmware version, interface and Bluetooth information, the device's Bluetooth name or address, communication mode, and printing and memory settings on the diagnostic receipt. Use the Bluetooth name shown on the receipt to identify the correct device.
2. Connect the mPOP via Bluetooth
- Turn on the mPOP. When starting up, the mPOP enters pairing mode; there is no separate PAIR button.
- Open the Bluetooth settings on the phone, tablet or computer you are using and make sure that Bluetooth is turned on.
- Find the mPOP name shown on the receipt in the list of devices (usually
mPOP-XXXXX) and select it to pair. - If the device asks for a PIN code, check the device-specific instructions. (Pairing the mPOP usually does not require a PIN code.)
- When the connection is shown as connected, select the same printer in the settings of the till application or printer software.
3. Remove the pairing and pair again
Remove the old pairing from both the mPOP and all devices that were previously connected to it before pairing again.
- iPhone/iPad: Settings → Bluetooth → tap the information icon next to the mPOP → Forget This Device.
- Android: Settings → Bluetooth → select the mPOP settings → Forget.
- Windows: Bluetooth & devices settings → select the mPOP → Remove device.
Restart the mPOP if necessary, find its Bluetooth name on the device again and pair it according to the steps above. If pairing is still not possible, resetting the Bluetooth settings may be necessary. Resetting removes saved pairing information and restores the Bluetooth settings, so only do this after the device has been forgotten on all connected terminals. The button and indicator light steps for resetting depend on the mPOP model.
4. Initial connection check
- Turn off the device. First disconnect all extra cables and USB devices from the mPOP. Leave only the power cable connected. This helps determine whether a peripheral device or cable is affecting the connection.
- Restart the mPOP and try to establish the Bluetooth connection again.
- If the connection is not established, remove the pairing at both ends and pair again.
- When the connection works without additional devices, reconnect the disconnected cables and USB devices one at a time. Test the connection after each addition. This helps identify any device or cable that may be causing interference.
5. Narrow down the issue systematically
- Check the power and printing: make sure that the mPOP starts normally, the paper is positioned correctly and the diagnostic receipt prints. If the receipt does not print, first investigate a power, paper or device fault.
- Check the Bluetooth information: compare the Bluetooth name on the receipt with the name you select on the terminal. Also record the firmware version and the interface and communication settings shown on the receipt.
- Test without peripheral devices: keep extra cables and USB devices disconnected while establishing the connection.
- Test another terminal: if possible, try pairing with another phone, tablet or computer. If the connection works with another device, the issue is more likely related to the Bluetooth settings or software of the original terminal.
- Test separately from the application: first make sure that the terminal establishes a Bluetooth connection to the mPOP. If the operating system connection works but the till application does not print, check the printer selection and connection settings in the application.
- Reconnect peripheral devices step by step: reconnect the cables and USB devices one at a time and test. Note after which addition the issue returns.
If the issue continues, provide Support with a photo of the diagnostic receipt, the exact mPOP model, the terminal model and operating system version, the name and version of the till application, and information about at which stage the connection fails. Also state which cables and USB devices were disconnected and whether the behaviour changed when using another terminal.
Comments
0 comments
Please sign in to leave a comment.